Skip to main content

How to Approve a Jet-Black Powder Coating Finish

Approve black powder coating on real panels under agreed lighting.

DAMEI POWDER COATING logo
By DAMEI POWDER COATING

November 9, 2026

How to Approve a Jet-Black Powder Coating Finish

On November 6, Birla Carbon previewed its CHINACOAT 2026 offering, including high-jetness carbon blacks for coatings and pigment dispersion for powder applications. For buyers, the practical question is what the finished assembly will look like. A pigment supplier's announcement does not establish the formulation or appearance of a DAMEI grade.

Use RAL 9005 to start the conversation

RAL identifies 9005 as Jet black. Specify that colour reference and the finish separately. A smooth glossy black can show a sharp reflected light source; a matte finish scatters the reflection. Two pieces ordered to the same colour reference can therefore look different side by side. A screen image also cannot show how either finish will behave on a folded edge or under the installation lighting.

DAMEI has two published examples from its outdoor pure polyester powder coating range: the RAL 9005-PB matte data sheet lists 20–30 gloss units (GU), while the RAL 9005-PA gloss data sheet describes a high-gloss grade. These are separate finish options. The GU value describes gloss; it does not measure blackness or guarantee a match between parts.

Approve the parts together

  1. Send a physical colour reference or an existing approved part. Name the surfaces that meet in the assembly, and state the target gloss, texture and any measurement method required by the drawing.
  2. Ask for coated samples on the production substrate with the proposed pretreatment, film build and cure. Include a profile or formed component when a flat panel cannot reproduce the installed shape.
  3. Place the samples next to each other in the same orientation. Check them under an agreed inspection light and, where possible, under the lighting in service. Decide what differences in hue, gloss or texture are acceptable before ordering.
  4. Sign and retain the agreed reference. Put its identifier and the selected grade on the purchase order. Compare the first production parts to that reference before releasing the rest of the order.

What to send DAMEI

When you request a sample comparison, include the substrate, indoor or outdoor exposure, a drawing or photo showing the mating parts, the colour reference and your preferred finish. Ask which grade and sample panel should go into the trial. Keep that panel with the specification so that the buyer, coater and inspector compare the same thing.

Share this post :
WhatsApp